Re: Allworx Reach
Posted: Mon Aug 26, 2013 9:34 am
Hello!
I will try on local LAN tomorrow. I tried here at my house and over 4G it won't work ever. Over my wifi it is about 50/50. Makes no sense as my connection is 30/15 here. I use a Cisco RV042G at the office and when googling that model and ALG I found a couple posts that said ALG is automatic on that router and cannot be disabled. Not sure if accurate. I updated firmware to latest last night and same issue.
I have a static IP public at office and I have put it in the nework config on the Allworx under "public IP" and rebooted it. Read where that it uses that to translate UDP ports back and fourth from router.
Any other info you have, let me know. Thanks for reply!
Andy
I will try on local LAN tomorrow. I tried here at my house and over 4G it won't work ever. Over my wifi it is about 50/50. Makes no sense as my connection is 30/15 here. I use a Cisco RV042G at the office and when googling that model and ALG I found a couple posts that said ALG is automatic on that router and cannot be disabled. Not sure if accurate. I updated firmware to latest last night and same issue.
I have a static IP public at office and I have put it in the nework config on the Allworx under "public IP" and rebooted it. Read where that it uses that to translate UDP ports back and fourth from router.
Any other info you have, let me know. Thanks for reply!
Andy