If anyone is interested in helping create a new site logo please email webmaster@allworxforums.com

PLEASE NOTE: Allworxforums.com is not owned, nor run by Allworx Corp. The views and opinions found on this forum are not necessarily the views of Allworx or the forum moderators. Neither Allworx nor the forum will be held liable for any information found on the forum. The Allworx logo and name is a registered trademark of Allworx Corp.

Paging stop working in a few minute after boot.

General installation and configuration help.
Post Reply
langthang
Posts: 1
Joined: Tue May 23, 2017 9:47 pm

Paging stop working in a few minute after boot.

Post by langthang »

I have a allworx phone connect as shown below
Allworx 8204 <-> Dell PowerConnect 2824 <-> Ubiquiti's PowerBeam <-> Ubiquiti's PowerBeam <-> Juniper EX3000 <-> Netgear GS748Tv5 <-> Allworx 48x
The 8204 is on the same subnet as 48x.
Paging work right after I reboot the phone but then stop. I have a ALGO 8103 setup to join multicast from 48x also works right after it boots up but not after few minute. Any idea how to troubleshoot?

TIA
Post Reply