Re: Allworx Reach Help
Posted: Tue Jun 26, 2018 2:37 pm
Ideally to have no issues, it would be best to connect the Allworx WAN directly to the cable modem / ISP and assign the Allworx WAN a static IP using what the ISP says to use as the gateway. If you have no static IP's then you would really want to buy a block of static IP's. You can do it via DNS but by sounds of it, it would be a simpler setup to manage by doing static IP's.radthomas wrote: ↑Tue Jun 26, 2018 2:15 pmThe Allworx does have a WAN IP in its network config. The WAN is showing as a Public IP. The default gateway is 255.255.255.0/24. (One thing I just noticed is that the WAN is marked as DHCP. Should I change to static and assign the Allworx LAN IP? We do also have the issue of sharing that WAN IP with our server's external access as well. So maybe that will not work, and could be some of our issue here.)sp90378 wrote: ↑Tue Jun 26, 2018 1:17 pmIn Reach, that is correct. You would want to put in the WAN. That is the easy way to tell how it gets out to the internet as well. Does the Allworx have a WAN IP in its network config? Is it a private IP or a public IP? And then what is the default gateway under network config as well, as with that info you can then tell if it is going through your firewall to get out to the internet.
I had figured out a way to access the admin website (adding :5060 on the end of the WAN) by having our firebox firewall policies point to the LAN IP of the phone system admin access (with :8080 appended as usual). However, I could not get the Reach app to connect until I deleted the :8080 off the LAN IP the Firebox directed the WAN:5060 for the Admin website. By deleting the :8080 I can now connect on the Reach, but not the Admin website.
I have no idea what settings will allow us access with the Reach/handsets, Allworx admin site and our server. Thanks so much for your help!